Sony PCV-RS410 Instrukcja Użytkownika Pobierz pdf (Strona 90)

Detach the power and drive cables from the original hard disk drive that is preinstalled in your computer.

Release the drive holder from the chassis by removing the drive holder screw.

Slide the drive holder out.

Removing the drive holder

Slide the new drive into the drive holder and align the holes on each side of the drive to the holes in the Drive

holder.

Secure the drive to the drive holder with screws, through the holes on each side of the drive holder.

Attaching the drive screws

Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing

the new drive to the drive holder.

10.

Realign the drive holder with the tracks on the inside of the chassis and slide the drive holder in completely.

11.

Reinsert the drive holder screw and tighten to lock the drive holder back into position.

12.

Reconnect the IDE and power connectors to the original drive.

13.

Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the

ribbon cable with pin 1 on the new drive.

Page 90

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 145 146

Brak uwag

Sony PCV-RS410 Instrukcja Użytkownika Strona 90