Rugged CCTV 5327 Cedar Creek, Kemp, Texas 75143, USA Tel: 866-301-CCTV, Fax: 903-498-8989
-9-Locate it in a proper place, after inserting the sliding groove part of the sunvisor into the rail of holder stand, and then tighten the fixed bolt
=RRP)RFXV$GMXVWPHQW1R+HDWHUW\SH+286,1*+286,1*&$3%2'<)81&7,21&21752/%2$5'=220+286,1*)2&86Unscre
+HDWHUW\SH8QVFUHZWKHIURQWKRXVLQJE\WXUQLQJFRXQWHUFORFNZLVH6OLGHWKHKHDWHURIIWKHOHQVDUHDDGMXVWWKHOHQVDVVKRZQRQWKHSUH
-12-Put the Heater back on, in its original position, after adjustment.Slide the housing back on as shown below. Screw the Housing clockwise to close
-13-The bracket assembly allows to tilt +25 ~ - 45 and to pan L/R 100 , making it possible to freely adjust the camera angle.Loosen the tilt lock
TROUBLESHOOTING If there is no picture on the monitor screen, make sure all the cables are properly connected. make sure the monitor is prope
SPECIFICATIONS ( Note: Design & specifications are subject to change without prior notice.) Model No. RB358 RB358H RB550 RB550H Image Pick-up Devi
DIMENSIONS-16-DIMENSIONSUNITS:mm352
CAUTIONCAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABL
PRECAUTIONSFEATURES-2-Safety The camera should be operated only from the type of power source indicated on the marking label. Do not disasse
-3-PART NAMES1. GLASS HOLDER : Retaining ring for front glass. (To keep the unit weather proof, do not unscrew this section)2. HOUSING : Unsc
CONTROLS ( DC12V / AC24V~ ) : Dual Power Type-4-1. INT/LL Internal/Line Lock selection. Internal : only DC12V Linelock : only AC2
-5- 13. LENS CONNECTOR 5. AGC ON/OFF Automatic Gain Control on/off6. ALC/ELC Auto-iris lens / Electronic shutter7. BLC ON/OFF Backligh
&21752/6326,7,21,17 // ,17(51$/6<1&2)) :% 21 :% 212)) :% 21 :% 212)) :% 21 :% 212)) $*&21 $872*$,1&21752/21$/&a
,167$//$7,21,QLWLDOFKHFN&KHFNDOOWKHFRQWUROVHWWLQJLQVLGHWKHFDPHUDEHIRUHLQVWDOOLQJLWWRHQVXUHDVPRRWKWURXEOHIUHH
-8-3 - 2. Connecting the Power Connect the appropriate cable to the power cable of the camera.Referring to the specified label of the camera.(Be s
Komentarze do niniejszej Instrukcji